From RCC structural drawings and foundation design to regular site supervision — Apnirman makes sure what gets built on site actually matches what was engineered on paper, at every stage of construction.
Whether it's a new independent home or an existing building that needs checking, the approach stays the same — engineer it right, then verify it on site.
Column, beam and slab design engineered for the building's actual loads and soil conditions.
Foundation type and sizing based on soil bearing capacity and structural load.
Reinforcement detailing and bar bending schedules ready for site execution.
Scheduled site visits to check reinforcement, shuttering and concrete quality before pours.
Condition assessment of existing buildings, with repair or retrofitting recommendations.
Material testing checks and documentation to keep execution accountable at every stage.
Every structural decision is checked against safety margins before it's checked against anything else.
Designs and drawings prepared to applicable IS codes and local building bye-laws.
Site visits scheduled at key construction stages, not just at the start and the end.
Site visit reports and photos shared directly with you, not just filed away.
Structural Drawings & RCC DetailingColumn, beam, slab design and reinforcement detailing for the whole structure.
Foundation DesignFoundation type and sizing matched to soil report and building load.
Site Supervision VisitsScheduled visits at foundation, plinth, each slab and finishing stages.
Quality & Safety ChecksReinforcement, shuttering and concrete grade verification before each pour.
Structural AuditsCondition assessment and repair recommendations for existing buildings.
Contractor CoordinationDirect coordination with site contractors to keep execution aligned with drawings.
Enter your area, floors and quality grade to get an instant estimate — free construction cost calculator, takes 2 minutes.
Soil investigation and load assessment for the site.
Foundation, column and beam design for the building.
Reinforcement detailing ready for site execution.
Scheduled site visits at every key construction stage.
Final checks and documentation before handover.
Concept previews shown below — real site photography will replace these directly.
[Add photo] Column and beam framework engineered for a multi-storey home.
[Add photo] Foundation execution supervised for reinforcement and pour quality.
[Add photo] A scheduled site visit checking work against the approved drawings.
Send over real project photos and this gallery will be updated with your actual completed work.
Structural design covers RCC structural drawings, foundation design, column and beam sizing, and detailing so the building is safe and code-compliant before construction begins.
Approved drawings only guarantee a safe design on paper — site supervision confirms that reinforcement, concrete grade, curing and execution on the ground actually match those drawings.
Yes. Apnirman conducts structural audits and condition assessments for existing buildings, and recommends retrofitting or repair where required.
Site visit frequency depends on the construction stage, but Apnirman schedules regular visits at key stages such as foundation, plinth, each slab and finishing to verify quality before work proceeds.
